Remove the toner cartridge if it hasn't already been removed. Open
Tray 1 (flips down). Remove the plastic piece circled below by pulling
straight out.
Next take a small flat head screwdriver or your fingernail
and pop open the blue tab on the pick-up roller. Then pull the roller
straight up and out.
When you replace the pick-up roller make sure the
blue tab is facing you and the pin is seated in the shaft (see below).
If you are replacing the separation pad (highly recommended), wait
to replace the pick-up roller until after you have replaced the
separation pad.
|
To
check prices or purchase an HP Laserjet 4100 maintenance kit 
